Skip to main content
← Back to equipment catalog
Plant glue / super glue gel

Representative photo. The product you buy may differ in size, colour or packaging.

Accessories

Plant glue / super glue gel

accessory

Used for: Aquascaping, Planted tanks, Tank maintenance

Specifications

SpecificationMICROBE-LIFT Plantscaper Super GlueRA AquaTech Aquarium Glue Clear for Plants
Pack size50 g5 g per tube, 20 g per pack
FormGelGel

Values as listed by each source when checked on 2026-09-17. Listings change.

Description

MICROBE-LIFT's Plantscaper is 50 g of super glue in gel form, sold for aquascape mosses and plants in freshwater aquariums, and the listing says it is made of cyanoacrylate. The directions are to put a small amount on the part of the plant to be glued and press the plant firmly for a few moments. According to the seller, a few drops are enough for a good result. RA AquaTech's glue, another cyanoacrylate gel sold for plants, comes as four aluminum tubes of 5 g each, 20 g in all. This paragraph, like the one above, is the seller's own account. The seller calls it an extremely thick gel that works underwater or above water, meant for live plants, small artificial decorations and small rocks; for large decorations or rocks it says to use silicone instead. According to the listing, the formula needs moisture to cure. In a dry setting the seller suggests spraying some water to speed curing, and it warns that excess glue left in air without enough moisture will not cure properly. Its advice is to put the glue on the point of contact between the two surfaces rather than around it. The listing gives a fixture time of 10 seconds to 30 minutes and a full cure of 10 minutes to 24 hours, depending on moisture and the amount of glue, and says that once the bond has partial strength the piece can go into the tank to finish curing underwater. The directions are to apply a small amount to the bottom of the moss or plant, press it against the surface for 20 seconds, and wipe the tip before replacing the cap. The listing's warning names cyanoacrylate and calls the glue an eye and skin irritant. It says to wear gloves and eye protection, keep the glue out of the reach of children, and rinse with water for 5 to 10 minutes and get medical attention at once if it gets in an eye.

Sources

Figures on this page were read off these pages. Manufacturers and databases do change or retire pages; if a link is dead, tell us with the correction link below.

Was this page useful? Spot anything wrong?